Miter Limit

The Miter Limit attribute can be used to set the angle of connected line segments where they join. The join will be more jagged or sharp depending on the entered or selected value.

Miter limits are relative to stroke size and become increasingly noticeable for line segments with increased thickness. The Miter Limit of a stroke (or line) can be altered by performing the following steps:

Step 1: Press on the Info Button in the Toolbar.

Step 2: Tap on the Stroke Tab.

Note: The Stroke Visibility option must be enabled for a Miter Limit change to appear in the Drawing Canvas.

Step 3: Tap on the On/Off toggle slider in the upper right hand corner of the Stroke Window to turn on the option. The slider will appear with a blue background when this option is enabled.

Step 4: To alter the Miter Limit, tap on the Plus/Minus Buttons next to the text entry field to increase or decrease the miter limit by increments of one or tap on the text entry field to open the text editor and type in a value.

Note: A miter limit change will be seen instantaneously when a stroke figure is selected. If no figures have been selected, the line cap change will apply to all subsequently created stroke figures.

---