Connection Type Overlay

When Overlay Mode is enabled and the Connection Tool is selected, a Connection Type Overlay will fade into the lower right hand corner of the Drawing Canvas.

The Connection Type Overlay application feature can be used to select the connector type before creating a connection line in the Drawing Canvas. Select the Connection Tool and then tap on the desired Connector Type in the overlay panel to change the current connection line type.

TouchDraw 2 will remember the current selection in the Connection Type Overlay and apply it to new connection lines created with the Connection Tool.

You must have the Show Overlays preference enabled for the Connection Type Overlay panel to appear in TouchDraw 2. See Overlays to learn more.

Note: To learn more about using connection lines in TouchDraw 2 and the available Connector Types, please refer to the Connection Tool section of the wiki documentation.

---